This might come a bit too late, since I get the Digest.
It is simply a matter of winding the coils in the other direction.
I think someone else posted comments on the list last week on that
matter.
You might also want to look for the information about the Connector
for he ribbon cable. There was a problem with the size of the holes
where the connector goes on the pcb. One suggestion was to carefully
file the connector pins before installing it. The other was to just
position it as best as you can and tack solder it in place, then
flow solder thru the plated thru holes from the top.
DO NOT ATTEMPT TO ENLARGE THE HOLES! It will likely ruin the PCB.
QRP DX TU (C) 1986 G.Danny Gingell, K3TKS@.abs.net
Maryland Milliwatt QRP Reference Library, (301)572-6789
[
QRP-L Archive |
]
[
1993 |
1994 |
1995 |
1996 |
1997 |
1998 |
1999 |
2000
]