Got to get caught up here...
Began to finish the job of final assembly that Larry began. There are ten
connectors/controls/other components which are mounted on the chassis and
handwired to the circuit board (my least favorite part of kit-building).
I am using the teflon wire I got from Jim Skalski, so that helps. (If Jim
has any more of that wire, get some. It's the best stuff I've seen!
Solders well, strips easily, doesn't melt, thin, flexible.)
Final wiring takes a bit of patience. The places on the board where wires
go are not marked, and some wiring (like the power regulator) is
point-to-point on the panel.
Before you send congratulatory flowers, there is lots of work left to do
before the fat radio sings.
Mike K1MG
[
QRP-L Archive |
]
[
1993 |
1994 |
1995 |
1996 |
1997 |
1998 |
1999 |
2000
]