Hello Folks -
Please excuse this message - I tried to send a message directly to
Christopher but it bounced.
Christopher -
Your EEPROM is probably not damaged. The contents were probably just
scrambled during the power "event". You can reset the configuration data
in the EEPROM by following the Resetting the Sidetone Frequency
procedure in the Operation part of the manual.
Since you stated that you had trouble with the sidetone adjust, you can
also try an undocumented reset of the keyer. This is accomplished by
holding down the speed key and then resetting the keyer with the reset /
kill key. However, you'll then have to change or reset the sidetone to
make the reset "permanent".
Best Regards,
Chuck Olson, WB9KZY
chuckolson@juno.com
Jackson Harbor Press
Washington Island, WI
[
QRP-L Archive |
]
[
1993 |
1994 |
1995 |
1996 |
1997 |
1998 |
1999 |
2000
]